15.1 Basic Installation

Briefly, the shell commands ‘./configure; make; make install’ should configure, build, and install this package. The following more-detailed instructions are generic; see the README file for instructions specific to this package.

The configure shell script attempts to guess correct values for various system-dependent variables used during compilation. It uses those values to create a Makefile in each directory of the package. It may also create one or more .h files containing system-dependent definitions. Finally, it creates a shell script config.status that you can run in the future to recreate the current configuration, and a file config.log containing compiler output (useful mainly for debugging configure).

It can also use an optional file (typically called config.cache and enabled with --cache-file=config.cache or simply -C) that saves the results of its tests to speed up reconfiguring. Caching is disabled by default to prevent problems with accidental use of stale cache files.

If you need to do unusual things to compile the package, please try to figure out how configure could check whether to do them, and mail diffs or instructions to the address given in the README so they can be considered for the next release. If you are using the cache, and at some point config.cache contains results you don't want to keep, you may remove or edit it.

The file configure.ac (or configure.in) is used to create configure by a program called autoconf. You need configure.ac if you want to change it or regenerate configure using a newer version of autoconf.

The simplest way to compile this package is:

1. cd to the directory containing the package's source code and type ‘./configure’ to configure the package for your system.

   Running configure might take a while. While running, it prints some messages telling which features it is checking for.

2. Type ‘make’ to compile the package.
3. Optionally, type ‘make check’ to run any self-tests that come with the package.
4. Type ‘make install’ to install the programs and any data files and documentation.
5. You can remove the program binaries and object files from the source code directory by typing ‘make clean’. To also remove the files that configure created (so you can compile the package for a different kind of computer), type ‘make distclean’. There is also a ‘make maintainer-clean’ target, but that is intended mainly for the package's developers. If you use it, you may have to get all sorts of other programs in order to regenerate files that came with the distribution.