Outline mode is a major mode much like Text mode but intended for editing outlines. It allows you to make parts of the text temporarily invisible so that you can see the outline structure. Type M-x outline-mode to switch to Outline mode as the major mode of the current buffer.
When Outline mode makes a line invisible, the line does not appear on the screen. The screen appears exactly as if the invisible line were deleted, except that an ellipsis (three periods in a row) appears at the end of the previous visible line. (Multiple consecutive invisible lines produce just one ellipsis.)
Editing commands that operate on lines, such as C-n and C-p, treat the text of the invisible line as part of the previous visible line. Killing the ellipsis at the end of a visible line really kills all the following invisible lines.
Outline minor mode provides the same commands as the major mode, Outline mode, but you can use it in conjunction with other major modes. Type M-x outline-minor-mode to enable the Outline minor mode in the current buffer. You can also specify this in the text of a file, with a file local variable of the form ‘mode: outline-minor’ (see File Variables).
The major mode, Outline mode, provides special key bindings on the
C-c prefix. Outline minor mode provides similar bindings with
C-c @ as the prefix; this is to reduce the conflicts with the
major mode's special commands. (The variable
outline-minor-mode-prefix controls the prefix used.)
Entering Outline mode runs the hook text-mode-hook followed by
the hook outline-mode-hook (see Hooks).