15.2 Overview of complex data FFTs

The inputs and outputs for the complex FFT routines are packed arrays of floating point numbers. In a packed array the real and imaginary parts of each complex number are placed in alternate neighboring elements. For example, the following definition of a packed array of length 6,

     double x[3*2];
     gsl_complex_packed_array data = x;

can be used to hold an array of three complex numbers, z[3], in the following way,

     data[0] = Re(z[0])
     data[1] = Im(z[0])
     data[2] = Re(z[1])
     data[3] = Im(z[1])
     data[4] = Re(z[2])
     data[5] = Im(z[2])

The array indices for the data have the same ordering as those in the definition of the DFT—i.e. there are no index transformations or permutations of the data.

A stride parameter allows the user to perform transforms on the elements z[stride*i] instead of z[i]. A stride greater than 1 can be used to take an in-place FFT of the column of a matrix. A stride of 1 accesses the array without any additional spacing between elements.

To perform an FFT on a vector argument, such as gsl_complex_vector * v, use the following definitions (or their equivalents) when calling the functions described in this chapter:

     gsl_complex_packed_array data = v->data;
     size_t stride = v->stride;
     size_t n = v->size;

For physical applications it is important to remember that the index appearing in the DFT does not correspond directly to a physical frequency. If the time-step of the DFT is \Delta then the frequency-domain includes both positive and negative frequencies, ranging from -1/(2\Delta) through 0 to +1/(2\Delta). The positive frequencies are stored from the beginning of the array up to the middle, and the negative frequencies are stored backwards from the end of the array.

Here is a table which shows the layout of the array data, and the correspondence between the time-domain data z, and the frequency-domain data x.

     index    z               x = FFT(z)
     
     0        z(t = 0)        x(f = 0)
     1        z(t = 1)        x(f = 1/(N Delta))
     2        z(t = 2)        x(f = 2/(N Delta))
     .        ........        ..................
     N/2      z(t = N/2)      x(f = +1/(2 Delta),
                                    -1/(2 Delta))
     .        ........        ..................
     N-3      z(t = N-3)      x(f = -3/(N Delta))
     N-2      z(t = N-2)      x(f = -2/(N Delta))
     N-1      z(t = N-1)      x(f = -1/(N Delta))

When N is even the location N/2 contains the most positive and negative frequencies (+1/(2 \Delta), -1/(2 \Delta)) which are equivalent. If N is odd then general structure of the table above still applies, but N/2 does not appear.