4.2.5 Removing Archive Members Using --delete

(This message will disappear, once this node revised.)

You can remove members from an archive by using the --delete option. Specify the name of the archive with --file (-f) and then specify the names of the members to be deleted; if you list no member names, nothing will be deleted. The --verbose option will cause tar to print the names of the members as they are deleted. As with --extract, you must give the exact member names when using ‘tar --delete’. --delete will remove all versions of the named file from the archive. The --delete operation can run very slowly.

Unlike other operations, --delete has no short form.

This operation will rewrite the archive. You can only use --delete on an archive if the archive device allows you to write to any point on the media, such as a disk; because of this, it does not work on magnetic tapes. Do not try to delete an archive member from a magnetic tape; the action will not succeed, and you will be likely to scramble the archive and damage your tape. There is no safe way (except by completely re-writing the archive) to delete files from most kinds of magnetic tape. See Media.

To delete all versions of the file blues from the archive collection.tar in the practice directory, make sure you are in that directory, and then,

     $ tar --list --file=collection.tar
     blues
     folk
     jazz
     rock
     $ tar --delete --file=collection.tar blues
     $ tar --list --file=collection.tar
     folk
     jazz
     rock
     $

The --delete option has been reported to work properly when tar acts as a filter from stdin to stdout.