6.1.4.2 Input/Output from BEGIN and END Rules

There are several (sometimes subtle) points to remember when doing I/O from a BEGIN or END rule. The first has to do with the value of $0 in a BEGIN rule. Because BEGIN rules are executed before any input is read, there simply is no input record, and therefore no fields, when executing BEGIN rules. References to $0 and the fields yield a null string or zero, depending upon the context. One way to give $0 a real value is to execute a getline command without a variable (see Getline). Another way is simply to assign a value to $0.

The second point is similar to the first but from the other direction. Traditionally, due largely to implementation issues, $0 and NF were undefined inside an END rule. The POSIX standard specifies that NF is available in an END rule. It contains the number of fields from the last input record. Most probably due to an oversight, the standard does not say that $0 is also preserved, although logically one would think that it should be. In fact, gawk does preserve the value of $0 for use in END rules. Be aware, however, that Unix awk, and possibly other implementations, do not.

The third point follows from the first two. The meaning of `print' inside a BEGIN or END rule is the same as always: `print $0'. If $0 is the null string, then this prints an empty line. Many long time awk programmers use an unadorned `print' in BEGIN and END rules, to mean `print ""', relying on $0 being null. Although one might generally get away with this in BEGIN rules, it is a very bad idea in END rules, at least in gawk. It is also poor style, since if an empty line is needed in the output, the program should print one explicitly.

Finally, the next and nextfile statements are not allowed in a BEGIN rule, because the implicit read-a-record-and-match-against-the-rules loop has not started yet. Similarly, those statements are not valid in an END rule, since all the input has been read. (See Next Statement, and see Nextfile Statement.)